چکیده

In order to increase insert ring lifetime in V94.2 gas turbine combustor, new upgrades have been presented in the current study. Since this part of the combustor is in direct contact with propagating flames produced by burner, it is important to consider a state-of-the-art cooling strategy. Based on the working condition of the insert ring, on the hot side, thermal barrier coating (TBC) has been considered. For lowering the temperature of the insert ring’s body, new sets of cooling holes have been taken into account. The results have indicated that by using TBC, heat flux rate dropped significantly. The maximum temperature happened to be less than 1110 K due to usage of TBC. But the temperature gradient remained unchanged. By increasing the cooling holes surface area through distortion of cooling holes, the temperature gradient in insert ring had dropped substantially. In addition, among the three presented cases, the best case for lowering the temperature gradient is the one with 48 oblique L-shaped cooling holes which dropped the maximum temperature by 15.7%.

کليدواژه ها

V94.2, Insert ring, TBC, Cooling holes, Combustion

کد مقاله / لینک ثابت به این مقاله

برای لینک دهی به این مقاله، می توانید از لینک زیر استفاده نمایید. این لینک همیشه ثابت است :

نحوه استناد به مقاله

در صورتی که می خواهید در اثر پژوهشی خود به این مقاله ارجاع دهید، به سادگی می توانید از عبارت زیر در بخش منابع و مراجع استفاده نمایید:
میلاد محمدی , 1400 , تاثیر چیدمان جدید سوراخ های خنک کاری و پوشش سد حرارتی بر روی اینزرت رینگ محفظه احتراق توربین گاز V94.2 , نهمین کنفرانس سوخت و احتراق ایران